I bought a SWE3 Humidity Sensor Module from Paul at Sheepwalk and since install its been hovering, not flat lining, around 75% as you can see. Im using the RJ45 connections and providing 5vDC the same as my other sensors but not getting any joy. :? The SWE0a Temperature Sensor I also have running off the humidity board is epic if anyone needs one, and Im sure I’ll get the humidity going too.
I have even plugged it in to the power injector by itself and getting the same results with the jumper in either spot.
I am using a decent cable length and have all wired the same as everything as i have some HB stuff mainly. Even plugged into the computer via the hub its no good. Paul is sending me another one after doing a heap of testing and establishing its the hum sensor.
I just had a look at your mods and they look great! Im running WD, would the solar mod just work the same as my old HB solar sensor?
Thanks for your help. I have found this had a faulty humidity sensor from new so it was replaced by Paul at Sheepwalk and now all is good. Thanks Paul!