Adding Sensors - Acurite VIS Data

Looking for a little assistance.

I recently changed out my weather station to an Acurite. The base unit is a model 06056M. I am running VIS Reader version 3.5.9.92.

Everything communicates, and updates as it should. I have the outdoor temperature from the 5 in 1, and the indoor temp from the base unit updating just fine.

However, I have added three auxiliary temperature sensors. They are recognized by the base unit as sensors A, B, and C.

Where can I find the data from them through VIS so that I can sync that into my testtags/clientraw file for integration into the website?

Any help would be greatly appreciated.

Thank you.

Mike

www.cripplecreekwx.com

its not very clear if VIS sees them?

Not sure where to look. I see RAW data, but I don’t know what I’m looking at.

See the attached screen shot of what I see.

It shows Translated Data for Outdoor and Indoor sensors.

Where would I look for the other sensors, and how do I see them in WD?


not sure
maybe reach out to the author?