Hello,
I have a problem with a specific station using weather display. The exact issue is that at some times, the program stops receiving data from the station(especially after a power outage) and either displays the last value from the station, either some random value from the data logger or just no data, i.e blank values. In the following graph you can see what i am talking about:
I tried to load some past data from the data logger, and for some reason it takes data for about half an hour or so, and then stops there, regardless the time span. For example if i set the logger to take data from 5 days ago, it will take data for only 1 hour or so and then it goes to the main screen. Practically the data logger is useless. I tried to take the batteries out of the console, and put them back again, switch also the usb ports and all that stuff, but nothing changed. The weather station is a fine offset WH1080 model. I even tried a completely new install, deleted all the registry settings, and again the same situation. It shows that it receives data, but all the values are frozen, i.e the temperature, humidity, wind speed etc.
In the Debug Info, it shows the following:
Doing checking of time zone calculation
Daylight saving not in use
Loaded all time records
usb Opened
Recording interval = 30
Start location = 112
Start location 2= 1
Start location final= 368
Minutes asking back = 148
looking for data from = 23:48:00
history position =305
new Offset needed 0
Doing checking of time zone calculation
Daylight saving not in use
history position =321
new Offset needed 0
history position =337
new Offset needed 0
checking to do housekeeping now from missed data
Normal daily resetting wind/temperature daily value , day: 25
Normal daily resetting rain daily value , day: 25 rain today 0.0 mm
history position =353
new Offset needed 0
history position =369
new Offset needed 0
usb Opened
Offset = 352 N = 1
Raw barometer 794.6
Raw indoor temp 20.2
Raw Outdoor hum =83
usb Opened
Offset = 352 N = 1
Raw barometer 794.4
Raw indoor temp 20.2
Raw Outdoor hum =83
usb Opened
Offset = 352 N = 1
Raw barometer 794.4
Raw indoor temp 20.2
Raw Outdoor hum =83
usb Opened
Offset = 352 N = 1
Raw barometer 794.4
Raw indoor temp 20.2
Raw Outdoor hum =83
I tried another software like Cumulus and it works fine, so there is not a sensor problem. I don’t understand what is going on.