done
OK
OK
OK
OK
VP reception #1 30640 #2 696 = 98
OK
OK
done
OK
It keeps repeating OK OK OK done etc
WD will not update if i select davis station type.
If i start WD, its fine, just no extra sensors. If i go to Station Type and Settings, drop down says Select Station. Within Davis tab, Davis Vantage Pro is highlighted in blue, as well as Davis rain gauge is 0.01 and baud rate. All sensors that i have enabled are unabled now. If i enable everything that i have, click Close and Save, then Ok…WD display freezes. No updates, but I can go to View, Davis Extra sensors, i can see all my sensors data, just isn’t refreshing. It’s almost like WD isn’t keeping my station fields in memory, but why does it lock/freeze up. I have always had Meteobridge enabled.
one problem is that meteobridge is not tied to being just for Davis VP
i.e it works with other hardware as well
WD should though be picking up the extra sensor data that it does provide
what I need to make is that with the meteobridge selected, the Davis extra sensor screen will get updated to show the extra sensor data that is coming through from the meteobridge
Brian, if you need to do some testing and access to a Meteobridge connected to a VP2 with similar configuration, leaf wetness, and soil. Just send me a PM and I will configure access
I even thought about doing an uninstall, removing everything wd etc and installing again. Maybe there is something corrupt. But I don’t know my registration key. Just a thought…I guess that’s why I am here
Did the update. All settings stayed after restarting. Soil temps showed up. WD still seems a bit laggy. Might be my laptop. Let me get a new laptop and I will report back. Thanks
what I should do is have the data gathered by a separate cron program
I can do that, and just need a tester
(or even better have someone make their meteobridge available via port forwarding)
I have the same problem as in the first post.
I have a vp2plus connected witch meteobridge, I set in WD the ip of meteobrigde and it’s works great.
only the extra sensors (soil) does not work, it’s only works if I select a davis station type as well than I can see it in davis extra sensor view, but the data are not logged (I need it for my website).
also after restart WD the station type is uncheked.
If you needed I can make my meteobrigde available.