Configuration Netatmo

Bonsoir,
Je ne comprends pas comment installer cette station “Netatmo” avec Weather Display.

Pouvez-vous m’expliquer.

Merci

you just need to set the station details
i.e username and password
which you will have your netatmo cloud data account
int the netatmo weather station type setup in WD
and tick enabled and then click on save/close

Merci Brian.

Sous Weather Display y a-t-il une possibilit

do you mean CO2?

Netatmo says it does “outdoor” air quality, I don’t know if that’s co2 but it’s what he’s looking for.

Air quality (no idea what units) comes from the “outdoor” unit, CO2 is measured by the “indoor” unit.


outdoor.JPG

indoor.JPG

i had not seen any air quality data in the raw data before
see if that is in the rawnetatmodata.txt file

They get it off the web #-o

“USA (the source is from the Environmental Protection Agency via the site Airnow)”

Oops, forgot the link https://www.netatmo.com/en-US/helpcenter/weather/1/the-outdoor-air-quality-measurement-does-not-appear-on-my-interface-is-this-normal/8

What a con!

Bonjour,
Donc impossible de r

it looks like its not possible, sorry, as its not provided direct
that file should be where WD is installed

Merci Brian.
Et le CO2 en interne ?

there is a custom tag available for the indoor CO2 data :slight_smile: