Ultimeter 2100 and gill windobserverII, ultimeter is also sendig wind

Hi, I managed to get my gill WindObserverII working,

Im using a Peet broos ultimeter2100 (no windsensor, its broken) as my main station, temp rain hum baro, and to day i got the gill anonemeter working.

Bug 1 : WD uses wind 0.0m/s from ultimeter2100 and curent wind from Gill WO2 , resulting in wd alternating witt curent wind and 0.0 wind.

Bug 2 : if gill WO2 is sett to H2 (heater enabled) and has not any voltage it reports a status code 65, looks like WD is expecting status code 00
I’m curently whit out a 24v power , but when it arives i can test , when WO2 sends status code 60 (heater on and working)

heater off :
data looks like : Q,288,004.74,M,00,1B
heater on, but no voltage :
data looks like : Q,256,014.36,M,65,0C , (note status code is going to be 60, when heater has voltage and working)

setup :
win7 whit WD 10.37S b81, gill windobserver (wind), ultimeter 2100 (temp/rain), 1wire (soiltemp, grasstemp, solarsensor-hobyboard)

Regards/73
Eivind