Hi everyone, Mike here form Palmerston North in New Zealand. I’ve had a Fine Offset WH1081PC for a number of years and has been a very good companion to me. However, last month I dismounted the sensors to replace the two AA batteries and while I was at it I also replaced the three AA batteries in the LCD display. When I powered it all back up the LCD display started to show some flashing icons for Min/Max alarms on temperature, wind and pressure. I had never seen these in all the resets or battery changes ever before!
No matter what sequence of buttons (soft) I press I cannot cancel the requirement to have an alarm set for one or all of the parameters.
Is this an unusual happening? Is it firmware related? I have had my LCD display connected to a PC and a Raspberry Pi previously but now it’s just standalone and is annoying the heck out of me!
Also, now when I connect to CumulusMX or EasyWeather software I get some strange readings on the computer (Win10 PC) that are not what is on the LCD display.
Thanks for any help if you can provide it.