Problems with data on graph!

Sometimes my weather station can’t send data to WD, and therefore some kind och “maximum” values for wind and gust showes up on WD… It looks like s*ht and the days maximum values for wind speed and gust become wrong.

Is there any solution for this problem?


I have put in place some better quality checks for that station type recently
so try a more recent update of WD
also you can set limits in WD , i.e so WD will ignore data outside those limits (see in control panel, offsets…/limits)

Thank’s! I’ve updated WD now.
I don’t think “limit” is the solution… But great differences between two close measures may be a warning signal that something is wrong with the collected data. Ex: if the wind is 4,2 m/s and the minute after is 25,9 m/s and next minute 4,2 m/s, WD should ignore the high value…
Is there a easy way to redraw the graph??
Regards
Lars

WD does have data spike checks for some of the weather stations that were prone to that (often was electrical interference → adding RF Chokes/baluns on any cables helped…I would try that)

you can edit the logfile and then convert the logfile to data file