Is there a ‘cheat sheet’ or a thread addressing how to customise either W-D or Win 10 - or both - in order for it to seamlessly run like it does on my old XP netbook (runs flawlessly day after day, booted once a month whether it needs it or not).
As time permits, I’m fiddling with WD-66 on a netbook with windows 10 on it and I’m plagued with little - sometimes big - things going awry.
Today, somewhere round 1400 local, I noticed WD was not running, so i started it again and it went straight into initial setup mode, all existing settings lost. I tried using last nights reg back up but that didn’t work either, so i cloned the prod system over to the win 10 test to get it running again - big one for me…Like w-10 auto-restarting after an update - wanted or not…
Little ones are about the UAC always asking if I want to run the pgm when I start it… Nuther littlie is I have WD set to autostart on boot, but it doesn’t. Also, after WD updates, I get prompts to run the cron…exe etc.
I tried looking thru the forum, but I didn’t seem to find things that might help, hence the question of a cheat-sheet or thread.
Any help gratefully accepted
Ken