Hobbyboards Solarsensor value stuck after update 10.37S b66

Hi,

All went well after updating to the latests version 10.37S b66, I think.
Except for my hobbyboards solarsensor.
It’s stuck at 134 w/m2 on the mainscreen graph and in the saratoga template.

The sensor is working, I can see in the dallasreader program, mV is changing so does the percentage in the wd solar set up.
Must be a setting here or there that might have changed and I am not seeing it.

what version were you using before

1037R b81

It’s at 0 now after trying a few things but it’s not getting input although the current readings in the Solar setup are working.
I see there is a hb1wireviewer now, should I be using that one instead of the dallas1wireviewer!

that was a big change in versions of WD (many years)
what I will need is your settings files (for how you originally had it setup)

wdisplay

you should never put your settings files on a public forum
I did say to email them
see the FAQ on how to send me the settings files
(as I need the registry settings files too)

try ticking
calculate % from raw compared to max
in the 1 wire settings in the control panel, solar setup

Thanks.

It is working again.