Baro Discrepancy between console and WD

Subject line says it all. How long has it been like this - no idea, but noticed it when comparing to the Win 10 test system.
It’s a 2315 setup, oldie but goodie.

The console indicates Baro at 28.69, and WD indicates 30.038 - a difference of 1.348 in/hg. 45.649 mb (if conversion was right).

It has been years since I used any of the ‘tweaking functions’ for any parameter and I’m not sure where I should start looking. Universal setup ? Offsets? And I’m even less sure about how to adjust.

Any pointers, info for me?

Thanks
Ken

you probably have a barometer offset set in WD
under control panel, offsets and initial rain

Thanks Brian, but no…

So that got me digging around and since we’re covered by a large high right now, I went to the 3 local airports, all +/- 100 ft of me (25-40 miles away) and all showed a pressure in the 30.nn range… So, digging further I found the console(s) for my stations(prod, test, win 10) are all incorrectly set up… The rel /absolute (s) are set wrong. Interesting, the prod system was setup in 2007 and it appears it’s been ‘off’ ever since. When I find the manual and some time I’ll correct it…

sigh

Ken