uRADMonitor Support

[Weather Display]

I don't follow...
all the user needs to know if the local IP address, and enter that in the setup (followed by /j)
no other API info is needed (i,e no user /pass or similar)

[abeasley]

Another question, Is this data getting uploaded to Weather Underground?

[Brientim]

Anything other than the IP Address should not be required.

Anything that concatenated (followed by /j or /json or a leading http(s):// etc) to make the connection string should be managed when the switch is enabled.

The unknown Variable is the IP address and they must enter it but the additional viarables for each connection string is known and there best managed by the software rather than user.

It was only a suggestion.

[Weather Display]

yes, i could check to see if the /j is added...if not. add it
yes the data is uploaded to WU
but they do not display it
(this has been discussed in the purple air thread)

[Weather Display]

you can set to plot the pm2.5 data in the WD main graph
see in the setup, advanced/misc setup for that and other options

[abeasley]

Interesting... it's being displayed for me (at least with the purple air)

[abeasley]

Here's a snippet of my wunderground data.

[Weather Display]

WU must finally have it integrated now then

[Brientim]

As far at I am aware, it is dependant of the type of station and as PA integration and is classified as a health device and is direct this explains the difference between what is being displayed.

[Brientim]

Brian just like to say thank you once again.