Just updated the app on my Android tablet (Samsung Galaxy Tab3 7.0) and on my wife’s iPad, and noticed for the first time that the readings from my only active extra temp/hum sensor are shown in the display as Extra Temp 1 and Extra Hum 2. Extra Hum 1 is blank.
Corresponding data is in the right place in clientraw.txt.
I have fixed this now, I was one out in the code (has always been like this, but this is the first time someone has reported it)
I will upload a fix now , should be in the google store in a few hours to update to
Am tagging my issue on this thread as it’s a similar problem.
The app works fine with all my extra temps except extra temp 6 which is my freezer temperature which is usually about -20 deg. C but the display just shows —. Is this because it can’t display negative temperatures? I’ve checked that the temperature is in the clientraw.txt file and it is (see attachment)
I’ve also noticed that on the screenshots shown on the WDliveapp page at the top it says “WEATHER DATA” whereas on my phone it says “SETUP”
Other than these points I’m very happy with the app