On the main screen, the soil temp is 50.7F. In the Dallas 1-Wire Reader, the Extra Temp #4 is 45.3F. In the Extra Sensor Real Time Graph, it’s 54.2F
There are no offsets entered…unless I’ve missed one.
what interval do you have set for the extra sensor graph update
ie are you comparing the same with same
and what custom tags are you using for the main screen to show those values
I’m not sure what you mean by custom tags. Labels? If so, Pond and Soil labels.
The pond is about 4000 gallons of water so not very fast to change. The soil temp probe is buried about 10 inches below the surface in a raised bed garden. Not fast to change either.
you can change the colour of some of the custom tags to use the data colour if you are using the latest update of WD
the font is the same otherwise as the other labels
The colour “tick box” control in S59 for Current Conditions custom labels isn’t “sticky”. Despite saving changes it reverts to the colour of the other labels on restart.
Colour for custom labels in Graph Area works OK. (It shows original colour at restart but then picks up the set colour when the graph values are populated.)
P.S. Not a custom label, but “BFT font size” isn’t sticky either.
Since my last post, the custom label in the Graph Area retains its colour at restart but not its size. I am now running S62, and I use “Set screen size 20% increase from normal”. The problems described below occur on the “Client” screen shown and the main (“Server”) screen.
Capture.JPG shows how I like the screen set up: lime green custom labels in Current Conditions and Graph Area; regular BFT font; and thin line for rain.
Capture2.JPG shows the screen after a restart: custom labels in Current Conditions now white like the standard labels; custom label in graph area still green but smaller; bold BFT; and thick line for rain.
The only way of correcting the labels is first to go into Control Panel/Colours/Labels Font and just OK the font shown (which resizes the Graph Area label but makes it white), then go into Setup/Advanced/Main Screen Customisation and OK the Graph Area label colour (which turns all custom labels back to green).
This is a daily chore, and so I usually can’t be bothered with BFT and rain. . . but it would be nice if they all stayed how I set them.
I have tested having a custom tag in the current conditions set to be the data colour
and that works OK on restart
and same for the graph area
are you using the latest update of WD?