VPlive not communicating

Hi folks, i was wanting to try out VPlive to see what the soil temp is really sending out,
weatherlink appears to only show soil #1 unless i go to plot more on the graph but thats
not really helpful in determining a precise readout. However, i am failing miserably to to
get the VP to communicate with VPlive :?

VPlive does not go higher than 19200, so i set the console ate 14400 and VPlive at 14400
and still no go for launch, am i missing something thats poking me in the eye please?

Is it cause im using a USB version? i thought that was ok cause theres mention of USB in
the readme but, im now thinking that its referring to using a serial to USB?

Are you trying to run VPLive and WD at the same time?
If so, do you have VirtualVP installed, as thatโ€™s the only way for both softwares to get the same data at the same time from Davis?

The standard baud rate for the VP2 is 19200, so Iโ€™d stick with that. :wink:

Hi Martin, i aint got a clue what i was on about re the baud rate, ignore that part please

WD was shut down, i do not have VirtualVP installed
Both are at 19200

I get, Failed to open archive and then unable to wakeup to console

Hi Martin, got it working, i downloaded the latest silabs driver, thanks

That would do it. :smiley:

I, i didnt think to install seen as it all connected to WL and WD straight out the box, no additional needed
evidently i was slight wrong on that one lol :slight_smile: