Software native RS-232

Merci Niko,
Je vais contr

Non

try a new .zip update of WD re the raw data showing under view, debug info, in WD

Brian,
J’ai install


DEBUG.PNG

[quote author=eongibier link=topic=63751.msg512259#msg512259 date=1478683532]
Non

have you clicked on connect (and set the needed com port number) in setup, misc…snow depth tab, Maxbotix setup?

Merci Niko.

Yes Brian.

[quote author=niko link=topic=63751.msg512271#msg512271 date=1478709021]
FTDI should be OK.

If you have a multim

Bonjour Serge

Did you test with the programme du terminal ?

Non Niko avec le : “the voltage on the MB pin 3”

OK, merci, so it’s clear for Brian:

Serge has tested the sensor’s analog output and it is working normally.

the screen shot of the settings in WD shows a different com port that the test software screen shot though

In the terminal program screenshot? That’s just a port that’s on my laptop, Serge didn’t test with a terminal program, he only tested the analog output. According to the maxbotix doc it should just default to sending serial data, but it would have been nice to test that independent of WD.

I could create a simple test com port program to test

That would be great :slight_smile:

Would it be simpler just add a screen to what you have now showing the raw data as it’s received?

the raw data as it is received should be showing in WD under control panel, debug info

Won’t that show the main station data, or can the sensor be selected?