Peut-
Please tell us which Maxbotix you have:
MB7334 or MB7354 or MB7364
?
I see you must have set to log the raw data
under setup, advanced/misc
untick that
so as to not confuse things
Bonjour Niko,
Capteur MB7354
Merci Niko,
Je vais contr
Non
try a new .zip update of WD re the raw data showing under view, debug info, in WD
Brian,
J’ai install
[quote author=eongibier link=topic=63751.msg512259#msg512259 date=1478683532]
Non
have you clicked on connect (and set the needed com port number) in setup, misc…snow depth tab, Maxbotix setup?
Merci Niko.
Yes Brian.
[quote author=niko link=topic=63751.msg512271#msg512271 date=1478709021]
FTDI should be OK.
If you have a multim
Bonjour Serge
Did you test with the programme du terminal ?
Non Niko avec le : “the voltage on the MB pin 3”
OK, merci, so it’s clear for Brian:
Serge has tested the sensor’s analog output and it is working normally.
the screen shot of the settings in WD shows a different com port that the test software screen shot though
In the terminal program screenshot? That’s just a port that’s on my laptop, Serge didn’t test with a terminal program, he only tested the analog output. According to the maxbotix doc it should just default to sending serial data, but it would have been nice to test that independent of WD.
I could create a simple test com port program to test