Static IP-Adress VP2

Hardware Weather Station Siting and Setup Tips
1

Hi

Does anyone know hot to give the IP-datalogger a static ip-adress, cause it

2

I don’t have one but IIRC if you open its current IP address in a browser you’ll get a setup page that allows you to set the IP. What IP you choose will depend on your network setup and what the router allows. Ask again if you need help with that part.

3

niko, I don

4

Limit of my knowledge then, sorry, need someone with experience :dontknow:

5

Put consol in setup mode and try again. The ip data logger is bissy, thats why you dont get access.
Then you change from obtain ip adress to use the following ip adress. Hop this helps you on the road :slight_smile:

6

Tried to put it in setup mode, no luck :frowning:

Anyone else have an idea?

7

Try to access the ip logger straight after total power off and on, of the wd consol.
It was a little tricky i remember.

8

try
go to your router direct from a browser window
e.g
192.168.0.1

then use the connected client list
then match it up (the IP address) via the DID number listed (which is stamped on the side of the IP data logger)

9

Brian

That did the job, made an exception in the DHCP scope at the router, then I got access to the loggers webinterface and set the ipadress.

Thank you very much :smiley:

Erik