Hello,
Today the first few Thunders were heard for the season.
I checked my computer, but nothing was detected there.
Suddenly I understood that there were absolutely no response in the Lightning detection software Nexstorm from Astrogenic.
There are no errors, as far as I can see, but even if I disconnect the antenna, no alarm or warning.
Then I tried the Lightning/2000 V4 which I have not used for years. This one did not even find the PCI-card…
I have upgraded to Win10 64bit last year, I suppose Lightning/2000 is not being supported any more and might not have the correct Win10 drivers?
And checking at Boltek, I was not able to find any good News either that might help me, just bad; the PCI-card is not produced any longer, discontinued last year.
The antenna itself is warm as it always has been. When I have tested before, I just shorted a 1,5V battery close to the antenna, this gave before lot of noise, but today absolutely nothing. I also changed the cable without luck.
Is there any way to test the antenna for Boltek Stormtracker?
Since the antenna is expensive, and this Boltek detector is discontinued, I would like to test the Antenna I have before spending close to USD 150.
If any Norwegians reading this and have Boltek system, I would like you to test my antenna on your system!
Regards
ts20
www.ts20.no