what psu would power a 12v 16w bulb
I have this temp switch that works fine with a 5w bulb
But if I try a 16w bulb the relay clicks and clicks, but, if
I move the bulb a little then the relay will activate it
I thought it may have been the psu, I i bout a variable
One that goes up to 12v 2amp, I am at a loss, is it the
temp switch or the psu that is struggling?
Well perhaps the switch cannot cope with the extra current with 16w you have around 1.4 amps. What is the switch rated at? If not that then it could be the PSU and if you do replace it go for one which has a higher current rating.
The switch is one of [urlhttp://www.ebay.co.uk/itm/50-110-C-Digital-Heat-Cool-Temp-Thermostat-Temperature-Control-Switch-DC12V-New-/152003309559?hash=item23641a6ff7:g:noEAAOSwBLlVVHA~]these[/url], rated at 10amp 8O I have tried 3 different psu’s and
i bought this latter one as its a 2amp at 12v. In theory, it should work, i can use 3 x 5w bulbs with no issues.
Perhaps a computer PS would be better, or will just have to forget the 16w and just use more of the 5w, shame though as i bought 10 x 16w lol
Hi, your power supply should be ok as a 16W bulb @ 12V = 1.3A ( watts divided by volts = amps), however is your power supply regulated, that means will it give you 12 volts @ 1.3 amps, it may be that the power supply voltage is dropping down when its under load. looking at the thermostat the relay should be ok for the 16w bulb, just check that you have wired it up correctly see UPLOAD, I think its the same thermostat that I have used on my heater here .
Hi guys, thanks, the cable I am using OS not much thicker than speaker cable, it was originally for a anti bark thing for outside, I will have to get the multi meter out and check out what is actually being given at yon end…
The other thing is that bulbs are lower resistance when cold so they take a big gulp of (inrush) current when you first turn them on which may glitch the supply voltage. Anytime you have electronics fed from the same supply as a switched big load you need a decent sized capacitor across the supply to handle the initial surge of current.
Ok, that just flew over my head but sounds important lol
Just checked under load
5w 11.4v @2a
16w 9.7v @1-2a it was fluctuating between 1 and 2 amps
So, thats not enough to power the 16w, so it looks like i am gonna need a PC psu
But, at least that should then power both fans in the shield and the 16w bulb, at the
minute i am, using 2 separate psu’s
Where did you check the voltage at the end of the cable or at the power supply, it needs to checked at the end of the wires, near the thermostat you could use one of these say a 12v 3.2amp, some are water proof.
Well, I got a PC psu, 200w and it still will not power the 16w bulb, it must be the temp switch not handling it
On the upside, its now powering 2 rain gauge heaters (home made), 2 fans in my shield and a 12v in the Davis shield
where as before the fans and the bucket heater was on separate psu’