cloudy
« previous next »
Pages: [1]   Go Down

Author Topic: New Barometer stuck on 0.0hpa  (Read 296 times)

0 Members and 1 Guest are viewing this topic.

Offline Phoniclynx

  • Posts: 427
  • Adelaide, Australia
    • Tucker's Weather Station
New Barometer stuck on 0.0hpa
« on: September 02, 2010, 11:17:37 AM »
I just bought a new barometer from HobbyBoards including a power injector. However WD is reading the baro as 0.0hPa but the voltage is 4.950v just at the current and the indoor temp is the same. I don't know if its totally set up right.. but I've tried.. any hints as to how I can test or what I can do differently?
Logged
Tucker
Adelaide Australia.
Dell Lattitude Laptop, 1GB, 500GB HDD
AAG 1-Wire Network, Baro, Humidity Sensor, V3 Weather Station, Rain Gauge, Solar Sensor, HUB
Tucker's Weather Station

Offline niko

  • syzygy
  • Global Moderator
  • Posts: 21,998
  • Crystal Ball broken! Please post the URL.
  • Northern California, U.S.A.
    • http://www.realweatherstation.com
Re: New Barometer stuck on 0.0hpa
« Reply #1 on: September 02, 2010, 01:33:27 PM »
You will need to fill in the values in those 4 boxes on the left. hi/lo baro and voltage so that WD knows how to convert the voltage output of the device to pressure. I'm guessing that calibration info is supplied with the unit.
Logged
Pages: [1]   Go Up
« previous next »