1-Wire+sensor UV+WD ayuda por favor

[meteonovoli]

hello, i  set this value already...now sun is low on my test  position it's 18.30 pm....and have raw value 0, tomorrow i will do new test.
thank you very much...
PS forgive my bad english...
Mauro

[meteonovoli]

Hello, i have all the setting ok, i  see the uv-rom and solar-rom in onewireviewer, but i don't have uv id-rom in main sceen in wd-dallas 1 wire-main/save setup!!! do you have this?

hello
control panel
solar sensor setup
solar max time of day time ...................
lengths is to set latitude
now in my panel
raw current reding
8.1 mv
tomorrow may not read the UV

[eb3bvb]

Hello
Here is my installation of a solar sensor + UV Sensor
Material used:
2 sensors
A waterproof case
1 box of modified network
4For cable 20 meters
A light diffuser that I had at home
Silicone, loctite

As you see in the pictures the plates are connected through the clamp and through these
4-pair cable box goes to the modified network, where I receive 12 V stabilized feed yy DQ signal of the sensors, which comes out to PC RJ

12V GND DQ


Continue ........
the trials to see how WD UV sensor detects

[eb3bvb]

continuing the previous topic
once in my power sensors, feed them with 12V and uni DQ signal from a sensor with the other
and mixed signal for the RJ to the computer.
onewireviever detected the perfect, or found out that WD had a UV sensor
watch off connect configuration, so for a week, nothing at all information 0 by the forum
tired and everything and break it off one day, then I mount the previous post and I connect to
pc Hallelujah onewireviever all the best WD detected and me and the sensor detects UV? that has passed
rj cable not detected and straightforward if the strip "
of computer stuff that I have had more than a week with a headache
Deputy catches today
Now I have to calibrate this
greetings
emilio

[meteonovoli]

Hello tanks to help me, i have the same setting, and wiring connection, but i no have raw value!! after how many time you reda the raw value? it's immediately?
i write to hobby board, but they answer to me slowly!

[eb3bvb]

hello on Monday can give you more information on how to further configure the sensors and the station is now collecting evidence but no real data collected
not to take the temperature of the solar sensor to do
delete the ID of the sensor
off WD
open the file wdisplay.ini
find the line where you put the rom ID and remove it (the ID, not the line). Record and restart WD.,
OneWireViewer WD and can not operate at the same time, or one or the other but not both at once, stepped on the signals.
- You are using external power? I guess so, because the UV sensor needed. Eye that is stabilized and within the limits accepted by Hobby-Boards. And keep in mind that if you use it, there is a jumper on the solar sensor board must be set.